Daily Maintenance Of Optical Fiber Laser Marking Machine

- Dec 04, 2017 -

Daily Maintenance Of Optical Fiber Laser Marking Machine

This machine does not work, should cut marking machines power and the computer power.

This machine does not work, please put the field lens lens cover to prevent dust pollution optical lenses.

This circuit in high-voltage state when machine work, non-professionals, do not boot maintenance to avoid electrical shock hazards.

Any failures should immediately cut off the power of this machine.

Equipment used for a long time, the dust in the air will be absorbed on the focusing lens on the bottom surface, the light will reduce the power of the laser, effects of marking effect; heat too warm explosion causing optical lenses. When marking a bad effect, you should carefully check whether focus lens surface is contaminated.

If focusing mirror surface is contaminated, remove the focusing lens cleaning its bottom surface.

Remove the focusing lens should be especially careful, careful not to hit or hurt and also do not use your hands or other objects touching focusing mirror.

Cleaning method is to use ethanol (analytical grade) and ether (analytical grade) by a mix of 3:1, with a long-fibre cotton swab or lens paper into the mixture, gently scrub the focusing mirror surface of the lower end, wipe the side need to be replaced once a cotton swab or lens paper.

In the working process of marking shall not move marking machines, so as to avoid damage to the machine.

Marking machines not covered or placed on other articles so as not to affect the machine cooling.